70's Style Fender Jazzmaster, custom replacement waterslide decal in Black with Gold Metallic trim. Can be customized in the reverse. Gold Metallic with Black Trim. Two shipped with every order and instructions are available upon request via a PDF file.
Applying and cutting Waterslide Decals:
Cut your decal(s), trimming as closely as possible to your printed image. Place the decal in a bowl of room temperature water for about 10-15 seconds (Ultra Thin Media) and then remove and let sit on a paper towel until the decal will slide onto your work surface, I have been taking it out and removing any excess water and leaving it sit a little less than a minute. You can test if its ready by lifting it, try moving it between your thumb and finger to see if it slides, . Place decal edge to where you want it and slide the underside away from the decal keeping it parallel to the headstock. This ensures it slides off as flat as possible and minimizes wrinkles. Make sure your surface is a little wet, (couple drops smoothed out with your finger) to much will not allow the decal glue to adhere properly, use either water or a wetting solution such as Micro Sol or Micro set. Please allow to dry overnight. Apply your first coat of your favorite lacquer.